300W Xenon Lamp

Product Detail

Product Overview
SZN-1202 Xenon Lamp is a super power and smart performance flash lamp for intelligent traffic system. Under dark environment, it provides high power fill flash and helps intelligent traffic camera to capture clear and colorful picture of number plate and human face in the vehicle. It has easy operated function of manual brightness adjustment to get proper light effect. With excellent performance, convenient installation and long life time, this product is superior in the market.

	?
Capture Picture-1	Capture Picture-2

Produce Feature
1.Easily adjust light brightness in the field.
2.High output of instantaneous light power with uniformity of light spot.
3.Longer life time than normal flash lamp.
4.Instant relighting, assure continuously multiple flash per second. 
5.Suitable in variety of working environment.
6.Less reflective.
7.Colorful picture available.

Specification

Model		SZN-1202
Synchronous Interface		One port capture trigger input
Power Supply		AC220V (AC165V~265V)
Power per flash		adjustable (80%?85%?90%?95%?100%)
Flash Times		more than 5million times
Power Consumption		Max. 300W
Recycle Time		0.001-0.1s
Flash Frequency		Support to continuously capture 2 pictures per time
Trigger Method		Dry contact
Reflective Bowl Angle		±15°
Protection Level		IP65
Color temperature		5600K (±200K)
Working temperature		-25~+50?
Storage temperature		-40~+85?
Weight		3.85kg
Size		320*190*190 mm

Hardware
1. SZN-1202 xenon lamp has power cable and control signal cable.



2. Power cable wiring definition.

Base Pin	Color of outgoing wire	Signal	Remark
1	Brown	Power line
2	Blue	Zero line
3	Yellow-Green	GND	Must be ground for safety

3. Control cable wiring definition.

Base pin	Color of outgoing wire	Signal & Function	Remark
1	Red	Trigger+	Falling edge effectively
2	Black	Trigger-
3	Orange	common line
4	White	Connect orange and white wire to get 95% power	Power adjustment
5	Yellow	Connect orange, white and yellow wire to get 90% power	Power adjustment
6	Green	Connect orange and green wire to get 85% power	Power adjustment
7		Connect orange, white, yellow and green wire to get 80% power	Power adjustment

Warning: Cut off the outer copper of unused wires and wrap them with electrical insulation type to avoid power reduce from short circuit.

The principle diagram of interface



Connection between camera and flash lamp

?

Dimension (mm)



Matters need attention
In order to get better performance of lamp, please pay attention to below:
1.Reflection of number plate may cause overexposure, please install the lamp in proper position and adjust the multiple exposures setting of camera to avoid this situation.
2.Camera shutter speed has influence to image effect at day and night, please make proper setting on it. Suggested setting is 1/100~1/250 or AUTO.
3.Lens aperture is a key factor affecting the imaging, please have a proper adjustment in field. The bigger F-rate the lower light flux, the smaller F-rate the higher light flux.
4.The power wire should connect to ground wire, otherwise may cause electrical shock.
5.The lamp contents high voltage power supply which is strictly prohibited to open, otherwise it may cause electrical shock.
6.In case that the lamp is overheated the circuit will stop working and after temperature down it will turn to work again.
7.Wires can't be tighten in case of waterproof purpose.

After sales service
1.In case that product damaged except artificial reason and the force majeure, we offer 5million flash times guaranteed of tube and 24 months warranty of control circuit, lifetime maintenance with cost price.
2.We keen to ensure the accuracy and completeness of content, but due to limited time we couldn't complete tests of all application area, any mistake are expected to be corrected.
3.We reserve the right to product design or material change.